APW Wyott M95-2-JIB - Manual (Page 8)

Also needed:
(Wet) terry towel
Catch pan for food soil (Butter Pan can be used)
Common kitchen scraper
If Teflon sheet is installed remove it when Bun Grill Toaster is .
Step 1. Set the toaster temperature to 350°F.
Step 2. Scrape loose food particles with scraper into Butter Pan under grill plate.
Step 3. Squeeze 1 to 2 ounces of Scotch-Brite Quick Clean Small Appliance Cleaner No. 702 or
equivalent into measuring reservoir of bottle. Pour cleaner onto pad. Do not pour directly
onto grill surface.
Step 4. using Scotch-Brite Multi-Purpose Pad Holder No. 405 or equivalent, and Scotch-
Brite Griddle Polishing Pad No. 46 (or 9650). (See Figure 3)
Step 5. After scouring, the surface clean with the Scotch-Brite Squeegee No. 410 (See
Figure 5)
Step 6. Turn off Bun Grill Toaster and wipe surface with clean wet towel. If the surface is still hot, use
the Scotch-Brite Multi-Purpose Pad Holder to move the towel over the surface. (See
Figure 5)
Step 7. Dry the grill thoroughly. Season the grill plate by applying a light coating of cooking oil to the
grill plate. Allow the griddle to heat up for 20 minutes. After 20 minutes season the grill
surface again by applying another coating of oil to the entire grill surface.
Step 8. Rinse all cleaning tools with hot water. (See Figure 6)
Step 9. Wipe down all external stainless steel surfaces with a damp cloth.
cool
Scour
squeegee
TM
TM
TM
TM
TM
8
FIGURE 3 FIGURE 4 FIGURE 5 FIGURE 6
Scour grill.
Clean grill surface
with squeegee
Wipe the grill with
clean wet towel.
Rinse tools with water.
RE-ASSEMBLY
Before assembling the conveyor check the following: Fasteners on the Conveyor Assembly
hardware should be tight with no signs of wear. Conveyor shaft gear and the Motor Shaft gear
are tight. Hanger Bracket screws are tight and the brackets have not shifted during use.
8. TROUBLESHOOTING GUIDE
Always ask and check the following:
1. Is the unit connected to a live power source of the proper voltage?
2. Check the circuit breaker.
3. Is power switch “ON” and pilot light glowing?
4. Check the rating label. Is the unit connected to the correct power source?
If the above checks out, and you still have problems, call an APW Wyott authorized service agent. APW
SERVICE HOT LINE: 1-800-733-2203.