Win-Holt WHSS-1 - Manual (Page 3)

Customer Service Bulletin
2
CUSTOMER SERVICE BULLETIN
The Win-Holt Film Wrappers are used to apply a thin plastic film or
protective plastic covering over packaging. They consist of a film
dispensing mechanism, a heated cut off rod, and a heated plate for
sealing the film.
DISPENSING MECHANISMS: AXLE
The Dispensing Mechanisms of film is axle. The wrappers are
available as table models for one or two rolls of film or a console
model for three rolls mounted on axles. Models accept film roll
widths up to 18”. Contact your film supplier for application information
regarding film thickness and color.
HEATED CUT OFF ROD
The Heated Cut-off Rod cuts the desired length of film. The
temperature is factory preset and controlled electronically.
HOT PLATE SEALING
The Hot plate is an aluminum casting with a bolt-on element. The
operator seals the ends ofthe film on the Hot Plate. The thermo-
stat which is mounted under the hot plate is adjusted by a plastic
knob mounted on the right side of the hot plate. Adjustment ranges
from”off to a maximum of 410°F. Temperature setting is determined
by film thickness, air temperature (kitchen or cooler) and operator’s
speed.
REPLACEMENT PARTS: IN-STOCK AND INTERCHANGEABLE
Replacement parts are available in stock for immediate shipment.
ELECTRICAL LOAD
Unit is rated at 8 AMPS, 115 VOLTS
New York • Pennsylvania • Georgia • Texas • California
China • India
800-444-3595 www.winholt.com