AVerMedia Technologies AVERDIGI EB5416DVD - Manual (Page 41)

35
OSD MENU Description
192 . 168 . 153 . 254
00 . 18 . 1A . 02. 00 . 0F
IP MODE
IP ADDR ESS
IP MODE
SUB NET
GATEWAY
MAC ADDR ESS
000 . 000 . 000 . 000 DNS
GET IP
192 . 168 . 153 . 100
DHCP
255 . 255 . 255 . 255
- MAC ADDRESS: Only for user information. Don’t need to
enter the MAC address.
- When all parameters are set, select the CHANGE to
confirm the configuration .
DHCP: Assign the IP address by local DHCP server to DVR
system.
i
The DHCP (Dynamic Host Configuration Protocol) is a
set of rules used by a communications device (such
as a computer, router or networking adaptor) to allow
the device to request and get an Internet address from
a server which has a list of addresses available for
assignment
Select GET IP to start getting IP. The DVR system will try to
get an IP address from the DHCP server. A message
window will show up as below:
G E T IP N O W . W A IT IN G . . .
If system didn’t get any network information, it means that
get IP from DHCP server fail.
PPPOE: Point-to-Point Protocol over Ethernet is a network
protocol for encapsulating PPP frames in Ethernet frames. It
is used mainly with ADSL services. If your network is using
ADSL service connecting to internet, and then, select
PPPOE mode, and then select GET IP. A message window
will show up as below:
G E T IP N O W . W A IT IN G . . .
If system didn’t get any network information, it means that
get IP from PPPOE server fail.
i
Please go to 8.1.1.5 Network Setup # PPPOE to
setup PPPOE account and password for connecting
to PPPOE server.