AVE MV DR8T - Manual (Page 8)

User’s Manual
2. System Setup
The notices and introduction on system installation will be described
particularly in this chapter. Please follow the description to operate the unit.
In order to prevent the unit from data loss and system damage that caused by
a sudden power fluctuation, use of an Uninterruptible Power Supply (UPS) is
highly recommended
2.1 Position the Unit
Position / mount the DRT16 / DRT8 DVR in a proper place and be sure to
power off the unit before making any connections. The placed location should
avoid hindering or blocking the unit from airflow. Enough airflow is needed
to protect the unit from overheating.
The maximum allowable temperature
of operating environment is 40°C.
The unit utilizes heat-conducting techniques to transfer internal heat to the
case, especially to the bottom side of the unit.
NOTE:
Be sure not to remove the rubber feet, and always leave
a space for air ventilation on the unit’s bottom side.
2.2 Selecting Video Format
The DRT16 / DRT8 DVR is designed to operate under either NTSC or PAL
video formats. The switch is positioned on the rear panel.
2.3 Connecting Devices to the Unit
This section lists some important notices that should be read before
making any connections to the DRT16 / DRT8 DVR.
NOTE: Connect short-term devices, such as USB ThumbDrive ® ,
USB CD-ROM, USB Hard Disk Drive, etc., only after the unit is
successfully powered up.
8