Avital AviStart 3000 - Manual (Page 31)

© 2001 Directed Electronics, Inc. Vista, CA 31
3. Transmit. While HOLDING the Program switch , press the button on the transmitter that you
would like to control the selected receiver channel.
4. Release. Once the code is learned, the Program switch can be released.
You can advance from programming one channel to another by releasing the Program switch and tapping it to
advance steps and then holding it. For instance: You have programmed Channel One and you want to program
Channel Two. Release the Program switch. Press it one time and release it to advance from Channel One to Channel
Two. Now, press and HOLD the Program switch. The LED will flash two times. As before, do not release it.
If you want to program Channel Three after programming Channel One, release the Program switch, press it twice
and release it to advance to Channel Three. Then press it once more and HOLD it. The LED will flash three times
to confirm it is ready to receive the code from the transmitter.
Learn Routine will be exited if:
■ Ignition is turned off.
■ Program switch is pressed too many times.
■ More than 25 seconds elapses between programming steps.
tach learning
To learn the Tach signal:
1. Start the vehicle with the key.
2. Within 5 seconds, press and HOLD the Program switch.
3. The LED will light constant when the tach signal is learned.
4. Release the Program switch.
DRW-96