Extron Electronics SW2 VGA DA2 A_AF Setup Guide - Manual

Setup Guide — SW2 VGA DA2 A/AF
This guide provides basic instructions for an experienced
installer to set up and operate the Extron
SW2 VGA DA2 A/AF switcher.
Installation
Step 1 — Mount the unit
Turn off all equipment or disconnect it from power sources and mount the switcher as desired.
See “Mounting the SW2 VGA DA2 A/AF” in the SW2 VGA DA2 A, SW2 VGA DA2 AF User’s
Manual for details:
• On desk — Place 4 rubber feet (provided) onto the four corners of the switcher.
• Rack — Use the optional 1U Rack Shelf, part #60-190-01.
• Under-desk — Use the optional Under-Desk Mount Kit, part #70-077-01.
• Through-desk — Use the optional Through-Desk Mount Kit, part #70-077-02.
Step 2 — Power connector wiring
Wire the power connector as shown to the right.
Step 3 — Video input
Connect an RGBHV, RGBS, RGsB, or RsGsBs video
input to each 15-pin HD connector, as desired. The
SW2 VGA DA2 AF has 1 video input and the
SW2 VGA2 AF has 2 video inputs.
Step 4 — Audio input
Connect an unbalanced stereo input to each 3.5 mm
stereo mini jack, as desired. The SW2 VGA DA2
AF has 1 audio input and the SW2 VGA2 AF has 2
audio inputs. Wire the audio plug as shown below.
(Continued on reverse side)
I NP U TS
1
2
A (L O C A L M O N IT O R )
B
1 2 I A
S
L R
AS/REMO
TE
SW2
VGA D
A2 AF
O U T PU T S
EXT SWITCH
12V
0.5A MAX
Laptop
LBC
Cable
Local Monitor LCD Projector Audio
Contact Closure
Control
Extron
SW2 VGA DA2 A
Switcher
Laptop
Power Supply
Output Cord
SECTION A–A
Ridges Smooth
A A
Captive
Screw
Connector
Tie
Wrap
3"
16 (5 mm)
Max.
Sleeve ( )
Ring (R)
Tip (L)