Extron Electronics VSW I AAP Setup Guide - Manual

Setup Guide — VSW I AAP
This guide provides basic instructions for an experienced
installer to set up and operate the Extron VSW I AAP.
VSW I AAP Interface
The VSW I AAP passive interface features a computer video
input and pass-through, an unbalanced stereo input and pass-through, and an input select
(Show Me) button. All VGA, audio, and control signals are carried from the rear panel of the
AAP to the switcher via a single Extron VGA/audio cable assembly.
Front panel features
a
Computer video input — Input VGA-UXGA, RGBHV, RGBS, RGsB, RsGsBs,
component video, or HDTV component video through this 15-pin female VGA
connector.
b
Audio input — Input unbalanced stereo audio through
this 3.5 mm mini audio jack. See the diagram at right.
c
Input select (Show Me) button — Pressing this button tells
the connected and compatible switcher to select this AAP as the
switcher’s active input. See “Rear panel features” below.
N The connected switcher must be compatible with this VGA pin 5 pull-up control feature.
The Extron VSW 2VGA A and SW VGA series switchers are compatible with this feature.
Check the user’s manuals for these switchers for more detail.
Rear panel features
a
Audio pass-through — Output unbalanced stereo audio through this 3.5 mm mini
audio jack. See the previous section’s wiring diagram (b).
b
Computer video pass-through — Output VGA-UXGA, RGBHV, RGBS, RGsB, RsGsBs,
component video, or HDTV component video through this 15-pin female VGA
connector.
N Be sure that all VGA cables contain all 15 pins and wires.
Interfacing to SW VGA Series Switchers
The VSW I AAP can be connected to each input of a SW VGA switcher. Pressing the Show
Me button causes the switcher to select this input. Refer to the SW VGA Switchers manual for
connection instructions. See the following example application diagram.
(Continued on reverse side)
VSW I AAP COMPUTER
AUDIO
SHOW ME
1 3 2
1 2
Sleeve ( )
Ring (R)
Tip (L)
3.5 mm Stereo Plug Connector
(unbalanced)