IEI Integration PCISA-945GSE v1.10 - Manual (Page 81)

PCISA-945GSE CPU Card
Page 63
Step 2: Insert the connector. Connect the FDD cable connector to the on-board
connector. See Figure 4-9. A key on the front of the cable connector ensures it
can only be inserted in one direction.
Figure 4-9: FDD Cable Connection
Step 3: Connect the cable to an FDD device. Connect the connector at the other end
of the cable to an FDD device. Make sure that pin 1 on the cable corresponds to
pin 1 on the connector. Step 0:
4.9.6 Parallel Port Cable without Bracket
The optional parallel port (LPT) cable respectively connects the on-board LPT 26-pin box
header to an external LPT device (like a printer). The cable comprises a 26-pin female
header, to be connected to the on-board LPT box-header, on one side and on the other
side a standard external LPT connector. To connect the LPT cable, please follow the
steps below.
Step 1: Locate the connector. The LPT connector location is shown in Chapter 4.
Step 2: Align the connectors. Correctly align pin 1 on the cable connector with pin 1 on
the PCISA-945GSE LPT box-header connector. See Figure 4-10.