IEI Integration NANO-CV-D25501_N26001 - Manual (Page 63)

NANO-CV-D25501/N26001 EPIC SBC
Page 48
Step 5: Secure the SO-DIMM. Release the arms on the SO-DIMM socket. They clip into
place and secure the SO-DIMM in the socket.
4.4 Jumper Settings
NOTE:
A jumper is a metal bridge used to close
an electrical circuit. It consists of two or
three metal pins and a small metal clip
(often protected by a plastic cover) that
slides over the pins to connect them. To
CLOSE/SHORT a jumper means
connecting the pins of the jumper with
the plastic clip and to OPEN a jumper means removing the plastic clip
from a jumper.
The hardware jumpers must be set before installation. Jumpers are shown in Table 4-1.
Description Label Type
AT/ATX power selection JP3 2-pin header
Clear CMOS JP1 3-pin header
LVDS1 voltage selection JP5 3-pin header
LVDS2 voltage selection JP4 3-pin header
LVDS2 resolution selection SW1 DIP switch
PC/104-Plus VIO voltage selection JP2 3-pin header
mSATA/PCIe Mini mode selection MSATA_SW1 2-pin header
Table 4-1: Jumpers
4.4.1 AT/ATX Power Selection Jumper
Jumper Label: JP3
Jumper Type: 2-pin header