IEI Integration NOVA-945GSE v1.01 - Manual (Page 88)

NOVA-945GSE 5.25” SBC
Page 88
o When working with the NOVA-945GSE, make sure that it is disconnected
from all power supplies and that no electricity is being fed into the system.
Before and during the installation of the NOVA-945GSE DO NOT:
Remove any of the stickers on the PCB board. These stickers are required for
warranty validation.
Use the product before verifying all the cables and power connectors are
properly connected.
Allow screws to come in contact with the PCB circuit, connector pins, or its
components.
5.2.2 Installation Checklist
The following checklist is provided to ensure the NOVA-945GSE is properly installed.
All the items in the packing list are present
A compatible memory module is properly inserted into the slot
The CF Type I or CF Type II card is properly installed into the CF socket
The jumpers have been properly configured
The NOVA-945GSE is inserted into a chassis with adequate ventilation
The correct power supply is being used
The following devices are properly connected
o Primary and secondary IDE device
o SATA drives
o Power supply
o USB cable
o Serial port cable
The following external peripheral devices are properly connected to the
chassis:
o VGA screen
o Keyboard
o Mouse
o RS-232 serial communications device
o USB devices