IEI Integration ECW-281B-N270-WT v2.00 - Manual (Page 64)

ECW-281B Embedded System
Page 48
Step 7: Adhere the thermal pad to the HDD. Make sure there is no obstacle covering the
breather hole (
758H758H758H
Figure 4-5).
CAUTION:
Make sure the breather hole of the HDD is not covered. Covering the breather
hole may cause damage to the HDD.
Figure 4-5: HDD Thermal Pad
Step 8: Replace the HDD bracket onto the bottom surface by aligning the four retention
screw holes in the HDD bracket with those in the back of the bottom surface.
Step 9: Reinsert the four previously removed retention screws.
Step 10: Connect the SATA cable connector in the ECW-281B/281B2-R20 to the HDD.
Step 11: Replace the bottom surface to the bottom panel by reinserting the six previously
removed retention screws. Step 0: