IEI Integration uIBX-200 v1.02 - Manual (Page 78)

uIBX-US15WP Embedded System
Page 69
Figure A-1: Recovery Tool Setup Menu
Step 5: Press <5> then <Enter>.
Figure A-2: Command Mode
Step 6: The command prompt window appears. Type the following commands (marked
in red) to create two partitions. One is for the OS installation; the other is for
saving recovery files and images which will be an invisible partition.
(Press <Enter> after entering each line below)
system32> diskpart
DISKPART> list vol
DISKPART> sel disk 0
DISKPART> create part pri size= ___
DISKPART> assign letter=N
DISKPART> create part pri size= ___
DISKPART> assign letter=F
DISKPART> exit
system32> format N: /fs:ntfs /q /y
system32> format F: /fs:ntfs /q /v:Recovery /y
system32> exit