14 rs-232 serial port connectors, Figure 3-29: serial device connector – IEI Integration TANK-700-QM67 v1.12 User Manual
Page 49
Advertising
TANK-700 Embedded System
Page 37
3.9.14 RS-232 Serial Port Connectors
CN Label:
COM1
, COM2, COM3 and COM4
CN Type:
DB-9 connectors
CN Location:
CN Pinouts:
See Table 3-11 and Figure 3-30
RS-232 serial port devices can be attached to the DB-9 ports on the rear panel.
Step 1:
Locate the DB-9 connector
. The locations of the DB-9 connectors are shown
Step 2:
Insert the serial connector
.
Insert the DB-9 connector of a serial device into
the DB-9 connector on the external peripheral interface. See Figure 3-29.
Figure 3-29: Serial Device Connector
Step 3:
Secure the connector
. Secure the serial device connector to the external
interface by tightening the two retention screws on either side of the connector.
Advertising