IEI Integration TANK-820-H61 v2.03 - Manual (Page 45)

TANK-820-H61 Em b e d d e d S ys te m
P a g e 32
Figure 3-20: RJ-45 RS-422/485 Serial Device Connection
S te p 3: Insert the serial connector. Insert the DB-9 connector of a serial device into
the DB-9 connector on the RJ-45 to DB-9 COM port cable.
S te p 4: Secure the connector. Secure the serial device connector to the external
interface by tightening the two retention screws on either side of the connector.
Figure 3-21: RJ-45 RS-422/485 Serial Port Connector
3.7.11 RS -232 S e ria l P o rt Co n n e c to rs
RS-232 serial port devices can be attached to the DB-9 ports on the rear panel.
S te p 1: Locate the DB-9 connector. The locations of the DB-9 connectors are shown
in Figure 1-2.
S te p 2: Insert the serial connector. Insert the DB-9 connector of a serial device into
the DB-9 connector on the external peripheral interface. See Figure 3-22.