IEI Integration ECN-680A-H61 - Manual (Page 38)

ECN-680A-H61 Em b e d d e d S ys te m
P a g e 24
S te p 6: Install the HDD bracket in the same position it was before and tighten the HDD
bracket retention screws.
S te p 7: Reinstall the HDD cover.
3.6 Wi-Fi An te n n a In s ta lla tio n (Wi-Fi Mo d e l On ly)
To install the Wi-Fi antennas to the ECN-680A-H61 series for efficient wireless network
transmission, follow the steps below.
S te p 1: Locate the antenna connectors on the rear panel of the embedded system.
S te p 2: Install the antennas to the antenna connectors (
767H767H
Figure 3-14).
Figure 3-14: Wi-Fi Antenna Installation
3.7 AT/ATX Mo d e S e le c tio n
AT or ATX power mode can be used on the ECN-680A-H61. The selection is made
through an AT/ATX switch located on the rear panel (Figure 3-15). To select AT mode or
ATX mode, follow the steps below.
S te p 1: Locate the AT/ATX switch on the rear panel (Figure 3-15).