IEI Integration PPC-WIDS-51xxA-G41 - Manual (Page 126)

PPC-51xxA-G41/WIDS-51xA-G41 Panel PC
Page 114
Step 5: Remove the retention screws that connect the PSU bracket to the chassis
(Figure 6-8).
Figure 6-8: PSU Rear Panel Screws
Step 6: Remove the retention screws that connect the PSU to the PSU bracket. Step 0:
6.6.2 Install the New PSU
Installation is done in the reverse order to removal. To install a new PSU module, please
follow the steps below.
Step 1: Attach the PSU bracket to the PSU module with the previously removed
retention screws.
Step 2: Insert the PSU module and bracket assembly into the chassis and attach the
PSU bracket to the chassis with the previously removed retention screws.
Step 3: Secure the PSU module to the chassis by reinserting the previously removed
retention screws through the bottom panel.
Step 4: Bundle the cables of the new PSU module and secure them with a plastic tie
similar to the old PSU module.
Step 5: Reconnect all previously disconnected power connectors to the motherboard
and disk drives.
Step 6: Reattach the elevated platform.
Step 7: Replace the back cover. Step 0: