Figure 2-8: attach foam tape, Figure 2-9: foam tape installed – IEI Integration ACT-457A User Manual
Page 29
Advertising
ACT-457A Panel PC
Page 21
Step 2:
Cut the adhesive foam tape as shown above.
Figure 2-8: Attach Foam Tape
Step 3:
Attach the adhesive foam tape to the edge of rear panel of the ACT-457A (see
Figure 2-8). Make sure the adhesive tape does not cover the screw holes as
shown below.
Figure 2-9: Foam Tape Installed
Step 4:
Select the position on the wall to mount the flat panel PC.
Advertising