IEI Integration AFL-4 series-N270 v2.10 - Manual (Page 37)

AFL-4 Series-N270 User Manual
Page 37
3.1 Unpacking
To unpack the flat panel PC, follow the steps below:
WARNING!
The front side LCD screen has a protective plastic cover stuck to the
screen. Only remove the plastic cover after the flat panel PC has been
properly installed. This ensures the screen is protected during the
installation process.
Step 1: Use box cutters, a knife or a sharp pair of scissors that seals the top side of the
external (second) box.
Step 2: Open the external (second) box.
Step 3: Use box cutters, a knife or a sharp pair of scissors that seals the top side of the
internal (first) box.
Step 4: Lift the monitor out of the boxes.
Step 5: Remove both polystyrene ends, one from each side.
Step 6: Pull the plastic cover off the flat panel PC. Step 0:
3.1.1 Packing List
Make sure all the components listed in the packing list are present. If any of these items
are missing or damaged, contact the distributor or sales representative immediately.
The AFL-4 Series-N270 flat panel PC is shipped with the following components: