Figure 2-3: hdd retention screws, Figure 2–4: hdd installation – IEI Integration AFL-W19A_W19B_17D_W15A-GM45 v1.06 User Manual
Page 28
Advertising
AFL-W19A/W19B/17D/W15A-GM45 Panel PC
Page 16
Step 5:
Attach the HDD brackets to the HDD. The brackets are different for each side.
Make sure the side with the hard drive screw hole further from the end goes at
the SATA connector end as shown in Figure 2-3.
Figure 2-3: HDD Retention Screws
Step 6:
Install the hard drive in the same position it was before.
Step 7:
Slide down from the top to connect the motherboard SATA connector to the hard
drive SATA connector.
Figure 2–4: HDD Installation
Step 8:
Fasten the screws.
Advertising