IEI Integration AFL-xxA-N270-Series v2.30 - Manual (Page 76)

AFL-xxA-N270 Series Panel PC
Page 60
Step 4: Remove the DDR memory module by pulling both the spring retainer clips
outward from the socket.
Step 5: Grasp the DDR memory module by the edges and carefully pull it out of the
socket.
Step 6: Install the new DDR memory module by pushing it into the socket at an angle
(Figure 5-5).
Step 7: Gently pull the spring retainer clips of the SO-DIMM socket out and push the
rear of the DDR memory module down (Figure 5-5).
Step 8: Release the spring retainer clips on the SO-DIMM socket. They clip into place
and secure the DDR memory module in the socket. Step 0:
Figure 5-5: DDR SO-DIMM Module Installation
5.5.2 CF Card Replacement
The AFOLUX AFL-xxA-N270 series has one CF Type II slot. To replace the CF card,
follow the instructions below.
Step 1: Follow all anti-static procedures . See Section 5.2.
Step 2: Turn off the power . See Section 5.3.
Step 3: Remove the back cover . See Section 5.4.1.
Step 4: Follow the instruction listed in Section 4.6 to replace the CF card. Step 0: