6 decoding, 1 decoding setting, Ecoding – IEI Integration HDC-3x-Series_SDK_Linux User Manual
Page 20: Hdc-3x series sdk (linux) page 20
HDC-3x Series SDK (Linux)
Page 20
1.6 Decoding
There three main procedures to decode video through the HDCapture SDK in Linux. First,
configure the decoding setting. Second, configure the video output port setting. Third, start
decoding video. These three procedures are described in the following sections.
1.6.1 Decoding Setting
Please connect the hardware and follow the instruction below to configure the decoding
settings before decoding the video.
Step 1:
Launch the HDCapture SDK (refer to Section 1.4).
Step 2:
Type 7 to select “7 Decode settings” from the main menu.
fmb-0?>7
Step 3:
The following message shows.
-------------------------------------------------------------------------------
-------------------------------------------------------------------------------
< Device list >
Select following number.
=== Card 1: HDC-304e ===
1 /dev/h55fmb0
2 /dev/h55fmb1
3 /dev/h55fmb2
4 /dev/h55fmb3
z Return
fmb-0?>
Step 4:
Select a port to configure by entering the port number. For example, type 1 to
select the first port.
fmb-0?>1
Step 5:
The following message shows.
< Encode settings - Sub menu >
‘Z’<-~~~~~~~~