IEI Integration ICECEARE-10W - Manual (Page 29)

ICECARE-10W Mobile Sales Assistant
Page 17
NOTE:
When the battery is low (below 9%), the power status LED blinks in red.
Please refer to the instruction described in Section 3.1 to charge the
sytem.
3.4 Using RFID Reader
There is a RFID reader on the rear panel. To use the RFID reader, follow the steps below.
Step 1: Check the RFID status indicator on the front panel to make sure the RFID
function is enabled (see Section 1.4.1). The RFID function is enabled by default
in the BIOS menu. If the RFID reader is disabled, please go to Chipset Æ
PCH-IO Configuration BIOS menu to enable it (refer to Section 5.4.1).
Step 2: Follow the instruction described in Section 4.7 to install the RFID driver.
Step 3: Double click the PcscTool icon in the RFID folder in the driver CD.