B.7 other information, Ther, Nformation – IEI Integration AVL-3000 User Manual
Page 142
AVL-3000 Advanced Auto Data Server
Page 128
NOTE:
A firewall or a SELinux is not in use in the whole setup process
described above. If there is a firewall or a SELinux protecting the
system, modify the configuration information to accommodate them.
B.7 Other Information
B.7.1 Using AHCI Mode or ALi M5283 / VIA VT6421A Controller
When the system uses AHCI mode or some specific SATA controllers such as ALi M5283
or VIA VT6421A, the SATA RAID/AHCI driver must be installed before using one key
recovery. Please follow the steps below to install the SATA RAID/AHCI driver.
Step 1:
Copy the SATA RAID/AHCI driver to a floppy disk and insert the floppy disk into
a USB floppy disk drive. The SATA RAID/AHCI driver must be especially
designed for the on-board SATA controller.
Step 2:
Connect the USB floppy disk drive to the system.
Step 3:
Insert the One Key Recovery CD into the system and boot the system from the
CD.
Step 4:
When launching the recovery tool, press <F6>.