Lincoln Electric IM10139 JUMP STARTER - Manual (Page 8)

D-1 MAINTENANCE D-1
JUMP STARTER
CHARGING THE POWER SUPPLY
1. Using a 120V AC Wall Outlet (preferred method)
Plug the female end of the cord onto the male plug
on the front of the power supply, then plug the
male end into the AC wall power (if you do not
have the cord that came with this unit, a standard
extension cord will work).
The red CHARGING light will come on indicating
the unit is being charged. When the green
CHARGED light comes on, the battery is charged.
This can take a day or longer depending on the
batteryʼs state of charge.
2. Using the 12VDc Charging Cord (alternate
method)
You can charge the Jump Starter using the 12Vdc
charging cord. Plug one end of the cord into the 12V
socket on the front of the Jump Starter, then plug the
other end into the vehicleʼs auxiliary power port while
the vehicle is running. Note that you do not want to
charge for more than 15 minutes as the current avail-
able from a vehicle can damage the Jump Starterʼs
battery if left in for more than 15 minutes
1. Recharge the unit if not used for 90 days.
2. Do not store the unit in temperatures that may
exceed 50° C.
------------------------------------------------------------------------
WARRANTY
For questions regarding warranty or use,
call 1-866-236-0044.
BATTERY REMOVAL AND DISPOSAL
This unit contains a sealed lead acid
battery. It must be disposed of
properly as dictated by Law. When
the unit / battery is in need of
replacement or disposal, remove it
according to the instructions below
and take it to your local recycling
center. Federal, state or local gov-
ernments may have additional regu-
lations to be followed in your area.
To remove the battery, lay the unit on itʼs front and
remove the screws holding the case together, lift the
back panel out of the way and remove the bolts con-
necting the cables to the battery. Be careful not to
short across the positive (+) and negative (–) termi-
nals with the tools being used or by laying the battery
on a metal table.
S29558-2
AC Extension Cord
S29558-1
Charging Cord
CAUTION
1. Never unplug the extension cord by pulling on
the cord. Do not use the extension cord if the
cord or plug is damaged.
2. Repairs should be performed by qualified ser-
vice personnel.
3. Do not allow the clamps to short circuit to
themselves or to any metal or conductive mate-
rial when stored (such as in the trunk of a vehi-
cle).
-----------------------------------------------------------------------
WARNING