Engine starting – Lincoln Electric IM10130 K3149-1 (11860) Wheel Charger User Manual

Page 14

Advertising
background image

14

3.

Set the RATE SELECTOR to START and try to start the
vehicle. If the vehicle

GRHVQ·

t start after 3 to 4 seconds,

stop and wait 3 to 4 minutes. Repeat until engine starts.

CAUTION

Excessive continuous engine cranking can damage
vehicle starter motors.

NOTE:

‡

If the engine spins but fails to start after sev-
eral starting attempts there is an engine prob-
lem not related to the starting system.
Discontinue cranking the engine until the
other problem is found and corrected.

‡

This battery charger has an internal thermal
protector to prevent overheating and damage
to the battery charger. If, after repeated start-
ing attempts, the ammeter registers zero out-
put, wait 3 to 4 minutes for the charger to
cool. The thermal protector will automatically
reset and allow you to continue.

NOTE:

‡

The length of charge times on these charts
are very accurate when using the RESERVE
CAPACITY or AMPERE HOUR battery rat-
ings. The COLD CRANKING AMPS and
MARINE CRANKING AMPS ratings are
approximations and vary from battery to bat-
tery. Always follow the battery manufacturer

·

s

specific charging instructions.

‡

Do not charge deep cycle batteries with a bat-
tery charger, or setting on a charger, that has
a rating of more than 25 amps. Follow the
battery manufacturer

·

s specific charging

instructions.

ENGINE STARTING

This battery charger can provide a high-current output to
help start a vehicle with a weak battery. However, the on-
board computer in some vehicles can be damaged when
attempting to jump start. ALWAYS READ THE VEHICLE
OPERAT

25·6

MANUAL BEFORE AUXILIARY STARTING

to determine if jump starting can do damage to the vehicle.
If not, read and follow these instructions.

CAUTION

Do not try to boost start a vehicle that does not contain
a battery or you may damage electrical system in the
vehicle.

1.

Connect the battery charger to the vehicle according to
OPERATING INSTRUCTIONS.

2.

Charge the battery for 5 to 10 minutes at the appropriate
charge rate for the size of battery.

Table 6. Length of Charge Time Chart 2 Amps

BATTERY RATINGS

HOURS TO CHARGE @ 2 AMPS

for the percent-of-charge now in the battery

0%

25%

50%

75%

100%

41.3

30.9

20.6

10.3

0.0

38.1

28.6

19.1

9.5

0.0

35.0

26.3

17.5

8.8

0.0

31.9

23.9

15.9

8.0

0.0

28.8

21.6

14.4

7.2

0.0

25.6

19.2

12.8

6.4

0.0

22.5

16.9

11.3

5.6

0.0

19.4

14.5

9.7

4.8

0.0

16.3

12.2

8.1

4.1

0.0

84.4

63.3

42.2

21.1

0.0

68.8

51.6

34.4

17.2

0.0

62.5

46.9

31.3

15.6

0.0

56.3

42.2

28.1

14.1

0.0

50.0

37.5

25.0

12.5

0.0

Approx.

Marine

Cranking

Amps

600

500

400

300

N/A
N/A
N/A
N/A
N/A

Approx.

Cold

Cranking

Amps

750

550

400

300

200

N/A
N/A
N/A
N/A
N/A

Ampere

Hours

66
61
56
51
46
41
36
31
26

135

110

100

90
80

Reserve

Capacity

(Minutes)

100

90
80
70
60
50
40
30
20

N/A
N/A
N/A
N/A
N/A

DEEP CYCLE*

HOURS TO CHARGE

Advertising
This manual is related to the following products: