Installation, Connection diagrams, Tig with s-series user interface – Lincoln Electric IM10118 POWER WAVE S500 User Manual
Page 11: Power wave, S500, Figure a.2
A-5
INSTALLATION
POWER WAVE
®
S500
A-5
CONNECTION DIAGRAMS
GTAW (TIG) WELDING
A user interface is required for adjusting the TIG weld-
ing settings. S-series user interface (K3001-2) can be
installed into the power source (Figure A.2). Refer to
the connection diagrams based on the user interface
that is being used. Alternate configurations are possi-
ble depending on the wire feeder that is being used.
Refer to the wire feederʼs manual for alternative config-
urations.
REGULATOR
FLOWMETER
GAS H
HOSE
FOOT A
AMPTROL
K87
870-2 12 PIN CONFIGURATION
0-2 12 PIN CONFIGURATION
(K2904-1 NECESSARY FOR
(K2904-1 NECESSARY FOR
K870 AND K870-1 6 PIN
K870 AND K870-1 6 PIN
CONFIGURATION)
CONFIGURATION)
WORK P
PIECE
WORK C
CLAMP
TIG T
TORC
RCH
K1783-2 OR -4
1783-2 OR -4
TO P
POSITIVE
VE ((+) S
STUD
TO R
REMOTE C
CONTROL
RECEP
EPTACLE
USE
SER I
INTERFACE
CONTROL PA
PANEL
K30
3001
01-2
GAS S
SOLENOID K
KIT
IT
(INSIDE M
MACH
CHINE)
PART OF K3001-2
PART OF K3001-2
USER INTERFACE
USER INTERFACE
WORK LEAD
WORK LEAD
K2149-1
K2149-1
TO N
NEGATIVE
VE ((-) S
STUD
TIG WITH S-SERIES USER INTERFACE
FIGURE A.2