Lincoln Electric 718113 Spirit II 150 - Manual (Page 48)

Section 4: Operation with Automatic Gas Console Spirit II User’s Manual
This information is subject to the controls of the Export Administration Regulations [EAR]. This information shall not be provided to
non-U.S. persons or transferred by any means to any location outside the United States contrary to the requirements of the EAR.
4-2
Important Messages and Icons
Messages and icons at the top of the screen provide additional important information.
Messages and Icons
Edge start is required
The power supply is ON
The power supply is OFF
A valve is open
Warning message - see Error Log
The system is cutting
The system is marking
Gas pressures are adjusting
Setup: Optimum
Current, pressures and gasses are set
to the cutting chart defaults for the
selected material and thickness.
Setup: Custom - Not Saved
Changes to cutting chart defaults have
been made but not yet saved.
Setup: Custom - Saved
Changes to cutting chart defaults have
been saved as a custom setup.