Master Manufacturing NO-Boom Kit - Manual (Page 2)

INTRODUCTION
The purpose of this manual is to assist you in the assembly, operation and maintenance of your sprayer or
accessories. Please read through this manual completely too fully understand how to operate and maintain your
equipment. This product has been manufactured to provide years of dependable service; proper operation and
maintenance will ensure its dependability. Keep your manual in a safe, convenient place for future reference.
Always mention the model and part number in any correspondence.
ASSEMBLY
The “No Boom” boom kit is designed to fit many applications. It has been specifically designed to attach easily
to other Master Manufacturing products. The following instructions are intended for the attachment of the “No
Boom” to a Master Manufacturing spot sprayer, lawn trailer, 3-point sprayer or ATV kit.
Manifold Replacement
1.) Remove the existing pump from the tank by removing the four screws.
2.) Remove the spray wand hose from the barb fitting on the outlet side of the sprayer pump.
3.) Remove the hose barb fitting from the outlet side of the pump.
4.) Obtain the new manifold (PN34-140068) and apply a thread sealant to the threads of the 3/8” male
NPT fitting located on the manifold. Thread the manifold into the outlet side of the pump and
tighten securely. Do not over-tighten manifold as pump head may crack.
5.) Reattach sprayer pump to tank using the screws removed from step 1.
6.) Push the spray wand hose onto the 3/8’ barbed elbow on the new manifold. Secure hose with new
hose clamp (PN SHC-F) provided.
7.) Apply a thread sealant too the gauge thread and thread gauge into manifold, tighten securely.
8.) If attaching manifold to a Master Manufacturing Spot sprayer, locate black grommet plug in top of
tank and remove it. Insert 12” tank return hose from manifold through hole into tank. On all other
tanks, an 11/16” hole will need to be drilled into top of tank within reach of the 12” hose. A wood
spade bit works the best (not supplied).
Spray Boom Attachment
1.) Attach the two upright spray boom brackets (PN 31-100160) to your lawn trailer, ATV angle
brackets or other application using the four 5/16-18 x 1 bolts (PN 33-100116) and 5/16 nuts (PN 33-
100113).
2.) Attach the spray boom (PN 34-140065) to the upright spray boom brackets using two 5/16-18 x 1
bolts (PN 33-100116) and 5/16 nuts (PN 33-100113).
3.) Thread on the boom hose to the manifold valve installed previously and tighten securely.
4.) Boom height can be 24” – 48” above area to be sprayed. Use the location holes in the upright spray
boom brackets as adjustments to obtain the optimum spray height.
Wiring Harness
1.) Attach the new wiring harness with inline switch to the sprayer pump by pushing the two terminal
connectors together.
OPERATION
Using the No Boom
∞ Four things must be considered before spraying with the boom.
1. How much chemical must be mixed in the tank?
2. Rate of spray (gallons per acre to be sprayed.)
3. What pressure (P.S.I) will be used.
4. Speed traveled (M.P.H.) while spraying.
5. Boom height and spray pattern
∞ Refer to the chemical label to determine the chemical mixture.