Northstar Trailers MULTISTAR - Manual (Page 10)

STEP 6: ASSEMBLE AND INSTALL LIGHTS
INSTALL TAIL/BRAKE LIGHTS
a. Fasten the taillight/brake light L-brackets (Q) to the frame using two, 1” bolts (L),
and one small lock washer (J) for each bolt.
b. Remove the nuts from the back of the taillight (O).
c. Determine the length of the wires needed to connect the wiring harness with the
light, then twist the wires together to shorten the wire slack.
d. Place the loop from the harness’s white ground wire over the closest stud on the
back of the light.
e. Connect the taillight wires with like colors from the wiring harness.
f. Slide the studs on the back of the taillight (O) through the L-bracket.
g. Slide the license plate bracket (R) onto the taillight studs.
h. Use the nuts from the back of taillight to fasten the light to the bracket.
i. Shove any excess wire back into the eyehole of the frame.
j. Tie off any wiring slack with a small zip-tie.
Note: follow the same sequence for the passenger-side taillight, but without the license plate
bracket.