Otter Outdoors Pro Ice Resort - Manual (Page 2)

Page 2
Otter Pro Ice Resort
Fits Large Otter II and Otter Pro Sled Only
Assembly Instructions
Tools Required:
7/16 Box End Wrench 3/8 Bit
7/16 Socket and Ratchet 5/16 Bit
Drill
Sled Size Required:
Large Otter II or Large Otter Pro
1. Layout all parts.
2. Position sled (Item 1) as shown
in Diagram 1, with curved front
to your left. Using front drilling
pattern (on back page) mark
two holes for the front frame
bracket with a sharp object.
Using rear drilling pattern (on
back page), repeat this step for
the rear frame bracket.
3. Drill the 4 marked holes using a
5/16 bit.
4. Drill the 3/8 in. hole in center of
lip approximately 16 inches from
bend in sled. The back wind
support bar (Item 5) is to be
propped here.
Diagram 1
Diagram 2
Item 20- 5/16 Washer
Item 21- 1/4 Nylon Hex Lock Nut
5. Bolt frame brackets (Item 3 and Item 4) to sled using holes predrilled in Step 3.
Use appropriate fasteners shown in Diagram 2.
Place front and rear drilling
patterns in these corners.
16 in.
3/8 in.
Hole
1
3
20
21
4