Palram Applications Snap&Grow - Anchoring Kit - Manual (Page 2)

Please read these instructions carefully before you start to
assemble this product.
Please carry out the steps in the order set out in these instructions.
Keep these instructions in a safe place for future reference.
Before you start
You will need
It is highly recommended to be assisted by a second person in some steps.
Sort the parts and check according to the contents parts list.
The product must be positioned and fixed on a leveled surface.
Make sure that screws and anchors suit the surface type.
This product is suitable for all Snap&Grow greenhouses up to 8 feet long.
Please be safe during assembly.
To assembly this product
(these items not supplied)
Safety
This product should be mounted to the ground as shown in these instructions
in order to ensure greenhouse’s stability and appropriate wind resistance.
Some parts may have sharp edges. Please be careful when handling
components.
Always wear gloves, eye protection, and long sleeves when assembling or
performing any maintenance on your product.
If using a stepladder or power tools please ensure that you follow the
manufacturer’s safety advice.
DO not lean the stepladder against the greenhouse.
Do not stand on the greenhouse roof/panels
To prevent injuries, do not allow children to play under the greenhouse
during assembly.
Care and Maintenance
During Assembly
Periodically check the product to assure that it remains stable.
Keep roof clean of snow.
During assembly you will encounter the information icon, please
refer to the relevant assembly step for additional comments and
assistance.
Do not cut the steel cable unless a final decision on the mounting location
has been made.
Step 3 : According to the ground surface type, follow the appropriate
mounting procedure.
Option 1 : for hard surfaces (concrete or wood)
Option 2 : soft/ground installation.
Step 5 : After the product has been installed, fasten the steel cable by
turning part #7332
Tighten all screws when completing assembly.
EN
x2