Poly-Tex Feria - Patio Cover 3000 - Manual (Page 2)

IMPORTANT
Please read these instructions carefully before you start to assemble this patio cover.
Please carry out the steps in the order set out in these instructions.
Keep these instructions in a safe place for future reference.
a Care and Safety advice
•
Please follow the instructions as listed in this manual.
•
Sort the parts and check the list of contents.
•
For safety purposes we strongly recommend that the product will be assembled
by at least two people.
•
Some parts have metal edges. Please be careful when handling components.
Always wear gloves, shoes and safety goggles during assembly.
•
Do not attempt to assemble the product in windy or wet conditions.
•
Dispose of all plastic bags safely – keep them out of reach of small children.
•
Keep children away from the assembly area.
•
Do not attempt to assemble the product if you are tired, have taken drugs,
medications or alcohol, or if you are prone to dizzy spells.
•
When using a stepladder or power tools, ensure that you follow the manufacturer’s
safety advice.
•
Do not climb or stand on the roof.
•
Heavy articles should not be leaned against the poles.
•
Do not hang or lay on the profiles.
•
Please consult your local authorities if any permits are required to construct the product.
•
Keep roof and gutter clean of snow, dirt & leaves.
•
Heavy amounts of snow on roof can damage the product making it unsafe to stand
below or nearby.
•
This product was designed and produced to be a patio cover only.
Some versions of this product are painted.
If color was scratched during assembly it can be fixed with the following tints:
White – RAL 9016
Gray – RAL 7012
a Cleaning instructions
When your product needs cleaning, use a mild detergent solution and rinse with cold
clean water.
Do not use acetone, abrasive cleaners, or others special detergents to clean the panel.
a Before starting assembly
•
This product must be assembled on a solid base (such as concrete).
•
Choose your site carefully before beginning assembly.
Site surface (mainly below poles) needs to be level.
•
During assembly use a soft platform below the parts to avoid scratches and damages.
EN
a Product dimensions adjusting
Product dimensions can be adjusted to your specific
needs.
1. The wall-mounting profile (top-back) can be adjusted
from 275 to 295 cm (108¼” to 116¼”) above ground.
The adjusting is done when measuring and drilling
(step 8).
2. Poles distance from the wall
can be adjusted from 210 to
276 cm (82¾” to 108½”).
The adjusting is done after
assembly and before anchoring
(step 23) by sliding poles and
profile 1041 at channels of roof
profiles.
3. Poles distance from the side
edges can be adjusted from
4 to 52 cm (1½” to 20½”).
The adjusting is done after
assembly and before anchoring
(step 23) by sliding poles and
connectors 937 at channel of
profile 1041.
Note: Wall mounting and
distance from the wall determine
the roof angle and the total
depth of the product
(distance of gutter from the wall).
Higher wall mounting
and shorter distance between
wall and poles increase the roof
angle and shorten the total depth.
275-295cm
108¼” - 116¼”
280 cm
110¼”
300 cm
118”
13 º 17 º