Poly-Tex W-TRUSS shade structure system - Manual (Page 8)

H
J
DETAIL A
DETAIL B
DIAGONAL CABLE INSTALLATION
REV: AD-120621
5
LOCK
WASHER
HEX NUT
INSTRUCTIONS:
1. Remove a 3/8" hex nut, lock washer, and flat washer from one corner fitting (DETAIL B).
Do not discard.
2. Fasten bracket on non-turnbuckle end of cable assembly to top fitting as shown in DETAIL B.
3. Adjust turnbuckle to make cable assembly as long as possible.
4. Remove 3/8" hex nut, lock washer, and flat washer from opposite corner of the 20' x 20' section
(DETAIL A).
5. Fasten bracket on turnbuckle end of cable assembly to top fitting as shown in DETAIL A.
6. Tighten cable assembly with the turnbuckle.
7. DO NOT OVER-TIGHTEN. The cable assembly should be taut but not pull the corners toward
each other.
TURNBUCKLE
FLAT
WASHER
LOCK
WASHER
HEX NUT
FLAT
WASHER