Qualcraft HitchClip Roof Jack - Manual

Roof Jack
Part #: 10572
Materials: aluminum.
Compliant with all applicable OSHA 1910 and 1926 regulations.
Roof Jacks are specially designed to be utilized during
construction as a staging area for workers, tools, materials,
and debris, and can be adjusted to fit a 6/12-12/12 pitch.
Maximum weight per pair of Roof Jacks: 2,600 lbs.
(including all workers, tools, and equipment).
UPC-A Code: 672421105727
Custom configurations not available. Not repairable.
Contact customer service for details.
Installation and Use:
Locking Pin
Staging Installation
Location
Headpin
(2) Roof Jacks required to set up a complete platform stage.
(1) HitchClip™ required per (1) Roof Jack.
ALWAYS use a complete and compatible PFAS, as determined
by a Competent Person, when working at heights 6’ or above.
NEVER make connections to Roof Jack.
1. Install all necessary HitchClips™ according to manufacturer’s
instructions. For use with Roof Jacks, recommended spacing
between HitchClips™ is 8’.
2. Insert Roof Jack Headpin into HitchClip™ key hole attachment
point from top to bottom, and ensure Roof Jack fully locks into
place. HitchClip™ and Roof Jack must be perpendicular to leading
edge of fall hazard.
3. Adjust Roof Jack so that platform staging will lie flat when
installed. Secure and lock Roof Jack with provided Locking Pin.
4. Place platform staging across Roof Jacks. Platform must be
construction grade lumber or better. Platform width must not
exceed 14”. Platform length must span across pair of Roof
Jacks + 2’, so that platform will overhang 1’ on each end. During
work, only work between Roof Jacks.
Q
ua
lc
ra
ft
In
du
st
rie
s
6
0
M
ap
le
S
t.
, P
.O
. B
ox
3
6,
M
an
sf
ie
ld
, M
A
0
20
48
ph
on
e:
(
80
0)
2
31
-5
64
7
w
w
w
.q
ua
lc
ra
ft
.c
om
Instructions