Ramsey Winch 800/H-800 DOW-LOK User Manual
Page 6
6
TROUBLESHOOTING GUIDE
CONDITION
POSSIBLE CAUSE
CORRECTION
CLUTCH INOPERATIVE OR BINDS
UP.
1. Dry or rusted shaft.
1. Clean and lubricate.
2. Bent yoke or linkage.
2. Replace yoke or shaft assembly.
OIL LEAKS FROM HOUSING.
1. Seal damaged or worn.
1. Replace seal.
2. Too much oil.
2. Drain excess oil. Refer to TECHNIQUES OF OPER-
ATION.
3. Damaged gasket.
3. Replace gasket.
LOAD DRIFTS DOWN.
1. Safety brake has become worn.
1. Replace brake disc. (See Page 7, Diagram 1).
2. Safety brake out of adjustment.
2. Turn adjusting bolt clockwise 1/4 turn or until load
does not drift.
WINCH RUNS TOO SLOW
1. Hydraulic motor worn out.
1. Replace motor.
2. Low flow rate.
2. Check flow rate. Refer to Hydraulic Systems flow
chart, page 5.
CABLE DRUM WILL NOT FREE
SPOOL.
1. Winch not mounted squarely,
causing end bearings to bind
drum.
1. Check mounting. Refer to WINCH MOUNTING
page 4.
CABLE BIRDNESTS WHEN
CLUTCH IS DISENGAGED.
1. Drag brake disc worn.
1. Replace discs.
HYDRAULIC FLUID LEAKS OUT
HOLE IN MOTOR ADAPTER.
1. Hydraulic motor shaft seal dam-
aged.
1. Replace seal.
ADJUSTMENT OF CLUTCH AIR SHIFTER
1. Place winch assembly back into mounting frame and reattach using (8) mounting bolts and lockwashers. Torque mounting
hardware to 290 ft. lbs. each. Make sure that gear housing and clutch housing are not rubbing against drum flanges.
2. Place air shifter assembly #1 over shifter shaft aligning clevis over flats of shaft. Secure clevis to shaft using clevis pin
#62 and cotter pin #61. Place shifter shaft in the "ENGAGED" position. With the air cylinder shaft fully retracted, push
shifter assembly toward the drum until all play is taken out of the shifter shaft. Secure shifter assembly to clutch housing
using (4) capscrews #39 (flanged hx. hd. serrated). Tighten securely, but do not torque.
3. Hook up air (70 to 90 psi) to inlet port of air cylin-
der and disengage clutch. Look into the opening in
the clutch housing and verify that the locking ring
and retainer plate are not making contact. Locking
ring and retainer plate must not make contact.
There must be a clearance (gap) of .09 inch
(max.) between the locking ring and retainer plate
when the winch is fully disengaged. If there is
contact, the (4) capscrews #39 should be loos-
ened and the plate pulled away from the drum
approximately .06 inch. Tighten screws securely
and check action to assure needed clearance.
Repeat adjustment procedure as needed to acquire
needed gap. Shift clutch 2 or 3 times to verify
proper shifting of clutch. After final adjustment,
torque (4) capscrews #39 to 18 ft. lbs. each.
Attach cover #43 using (4) capscrews #52.
16
28
36
WINCH ASSEMBLY
PLATE
RETAINER
LOCKING
RING
18
.09 MAX.
62
1
44
39
61
52