Ramsey Winch H 700 DOW-LOK W/ COUNTERBALANCE VALVE, LESS BRAKE - Manual (Page 10)

(4)
Remove counterbalance valve (item #65) from motor (item
#51) by removing (3) capscrews (item #39). Remove motor
from adapter plate (item # 20) by removing capscrews (item
#40). Remove adapter plate and coupling (item #2) from
adapter (item #3) by unscrewing (6) capscrews (item #38).
Remove key (item #16) from worm shaft. Unscrew (6)
capscrews (item #38) and remove adapter from gear housing.
Replace adapter seal (item #25) and gasket (item # 47).
(5)
Remove worm cap (item #7) by removing (6) capscrews (item
#36).Remove worm (item #22) and bearings (item #25) from
gear housing. Use a soft hammer to gently tap input end of worm
driving worm and bearing from gear housing. Once worm has
been removed from housing, bearing can be pressed from end of
worm.
Check for signs of wear or damage to worm (item # 22) and
bearings (item #25). Replace if necessary.
(6)
Remove gear housing cover (item #10) from gear housing
(item #14) by removing (8) capscrews (item # 33). Thread
(2) of the capscrews into the (2) tapped holes of cover and
tighten. This will pull the cover loose from the gear housing.
Remove cover gasket (not shown) and pull shaft (item #18)
with gear (item #13) and spacer (item #52) from gear
housing.
2
3
16
47
25
38
20
38
51
40
65
39
25
25
47
7
22
36
14
10
33
13
18
52
8