Ramsey Winch HD-P50000 W/TNR & 2 SPEED MOTOR - Manual (Page 11)

9
OM 914244-0712-E
10. Remove brake assembly screws #17 attaching brake #30b to end bearing #6. Remove coupling #4 and gasket #30e
from end bearing. Take note of mounting configuration for proper mounting of parts during re-assembly.
102
101
107
106
104
103
105
106
9. If splines inside drum driver #102 are damaged, drum driver must be replaced. Remove drum driver by unscrewing (8)
capscrews #105. If bushings show signs of wear, replace by pressing old bushings from drum #101 and removing o-
rings from grooves in drum and drum driver. Place well oiled o-rings #106 into driver and drum. Place well oiled o-ring
#107 on outside of driver. Press bushings #104 into drum driver until flange is flush and #103 is flush against drum
.
30c
30b
30e
17
6