Ramsey Winch RPH-16000 - Manual (Page 10)

8
STEP 3
Remove tie plates (item #11) from end bearings (items #3 and #6) by unscrewing capscrews (item #18), as
shown. Slide motor end bearing (item #3) from drum (item #1) and drum from gear housing end bearing (item
#6). Remove input shaft (item #10) and thrust washers (items #47 and #48) from end bearings. Inspect gear
teeth and splined end of shaft (item #10) for signs of wear. If necessary replace shaft.
STEP 4
Remove O-ring (item #37) and bushing (item #14) from outside of motor end bearing (item #3), remove O-ring
(item #32) and bearing (item #13) from inside of motor end bearing. Dip new O-ring (item #32) in oil and seat into
groove inside of end bearing and press new bearing (item #13) into end bearing. Press bushing (item #14) onto end
bearing and dip O-ring (item #37) in oil and seat into groove of end bearing.
Remove seal (item#40) from gear housing end bearing (item #6). Loosen nut (item #22) and remove nylon set-
screw (item #19) and remove ring gear (item #5) from gear housing end bearing. Remove bushing (item #15) and
bearing (item #12) from gear housing end bearing (item #6). Press new bushing (item #15) and bearing (item
#12) into place in end bearing. Install ring gear and nylon setscrew and nut. Ring gear must be fully seated in gear
housing end bearing (item #6) and slot in ring gear must be aligned with clutch shifter hole. Dip new seal in oil and
install in gear housing end bearing, with sharp edge of seal outward.