Ramsey Winch LEVEL WINDER 2 R.H. 256052 - Manual

INSTALLATION INSTRUCTIONS
FOR MODEL 2 LEVEL WINDER KIT #256052
This Level Winder is designed specifically for the Ramsey Winch Models Y200/Y300 Series Winches (Y200/Y300,
HY200/HY300 or DCY200/DCY300), which is 6.31 inches between drum flanges and the RPH8, IPH8, IPH10 Series
Winches with Y drum which are 6.50 inches (RPH) to 6.62 inches (IPH) between drum flanges.
NOTE: IF LEVEL WINDER IS BEING INSTALLED ON A CAR CARRIER (ROLLBACK), IT IS NECESSARY TO ALSO
INSTALL RAMSEY ROLLER GUIDE KIT, PART NO. 256053. FAILURE TO DO SO MAY CAUSE DAMAGE OR BREAKAGE
TO THE WINCH LEVEL WINDER OR VEHICLE.
INSTALLATION PROCEDURE
Disengage the winch clutch and free spool all the cable off the winch and lay it in a line on the ground behind the
truck. Disconnect the end of the cable from the cable drum anchor. Drill two .562 diameter holes through the hori-
zontal flange of the forward most winch mounting angle as shown in FIG. 1.
Insert the spring retainer into the springs so that the cleats of the retainer will extend toward the vehicle cab when the
assembly is in place. Slide the retainer so that the holes in the retainer line up with the hold down loops in the
springs. Position the holes in the retainer over the .562 diameter holes previously drilled in the flange of the winch
mounting angle.
Loosely attach the spring retainer and springs to the flange of the winch mounting angle using the 1/2 inch diameter
capscrews, nuts and lockwashers. After making sure the springs and spring retainer are aligned squarely with the
winch, as shown in FIG. 2., tighten the capscrews securely so that the springs are clamped hard down onto their
mounting surface.
NOTE: The surface to which the springs are bolted must be 1.25 +-.50 inch above the centerline of the drum barrel.
See FIG. 2, SECTION A-A.
Insert the end of the cable into the opening of the tensioner so that it passes under the center cross bar and over the
front cross bar and install the cable into the cable anchor. Bring the tensioner up to the winch and lift up first one
then the other of the spring tangs while sliding the center cross bar of the tensioner under the tangs. A pry bar will be
necessary to lift up the tangs.