Ramsey Winch CHEVY WRAPAROUND KIT 295361 - Manual (Page 2)

KI-913355 -0301-C 1
Step 1
Note: It is not necessary to remove or modify the vehicle bumper to install this mounting kit.
Remove and discard the three M12 bolts that secure the vehicle tow hook. They are located on
either side and on the bottom of the tow hook (Figure 1). Remove the tow hook assembly and set it
aside.
Step 2
Install left hand bracket assembly #7. Bracket is inserted
through the existing tow hook access in the air dam (Figure 2).
Replace the vehicle tow hook and secure using (1) M12 x 1.75 x
50mm bolt #13 and lockwasher #20 through bracket assembly,
frame, and into tow hook at each side and bottom of vehicle
frame (Figure 3). Do not tighten hardware completely.
Figure 1
Figure 2
Figure 3