Ramsey Winch CHEVY QM KIT 251068 User Manual
Page 2
KI-912600-0402-B
1
Step 1
Note: It is not necessary to remove the vehicle bumper to install this mounting kit.
Locate the three M12 bolts that secure the vehicle tow hook. They are located on either side and on the bottom of the
tow hook (Figure 1). Remove and discard the inside and bottom tow hook bolts only.
Step 2
YOU WILL NEED ASSISTANCE FOR THIS STEP.
Have someone hold the QM Front Receiver #5 in place between the two vehicle tow hooks (Figure 2). Insert (1) M12
x 1.75 x 50 mm bolt #1 through (1) ½” lockwasher #2, then through the “ear” of the receiver #5, the vehicle frame,
and into the threaded hole in the vehicle tow hook (Figure 3). Repeat for opposite side of vehicle.
Figure 1
Figure 3
Figure 2
Note: It may be necessary with some models to use ½” flat washers
#3 as spacers between the Front Receiver and the frame.