Ramsey Winch HD-234 (JERR-DAN) (NOT CURRENT) - Manual (Page 13)

13.Press bearing (item #14) onto worm and into
housing. NOTE: Be sure that thick shoulder of
bearings outer race (side with manufacturer's
name and part number) is out, away from worm
threads. Place gasket (item #29) onto adapter
(item #3). Attach adapter to gear hous-
ing using four (4) capscrews (item #22).
TIGHTEN CAPSCREWS TO 12 FT. LBS.
(16.3 Nm.) EACH. Insert key (item #11)
into keyway of worm shaft. Slide tapered
end of coupling (item #27) over end of
worm shaft. Be sure roll pin (item #38)
is in coupling.
Place motor shaft, with key in keyway,
into coupling. Secure motor to adapter,
using two (2) capscrews (item #23) and
lockwashers. TIGHTEN CAPSCREWS TO
75 FT. LBS. (102 Nm.) EACH.
14.Place winch with gear housing cover down on
work bench. Drum shaft should be in vertical
position. Slide thrust washer
(item #45) over drum shaft
and slide downward until wash-
er rests on gear housing. Set
springs (item #43) into pockets
of gear housing with drag
brakes (item #28) on top of
springs. Slide drum assembly
(item #7) onto drum shaft with
drum jaws upward.
13