Ramsey Winch HD-234 LEVER (CHAMPION) - Manual (Page 10)

4. Remove coupling (item #25) from adapter
(item #1) by unscrewing four screws (item
#21).
Replace adapter seal (item #42) and gas-
ket (item #30).
5. Remove bearing cap (item #2) from gear housing by unscrewing four capscrews (item
#20). Remove worm (item #14) and bearings (item #17) from gear housing. Use soft
hammer to gently tap input end of worm and drive worm and bearing from gear housing.
Once worm has been removed from housing, bearing can be pressed from end of worm.
Check for signs of wear or damage to worm (item #14) and bearing (item #17).
Replace if necessary.
Drag brake disc (item #26) and spring (item #40) should be examined and replaced if
necessary.
10
27
25
37
21
1
14
27
17
26
40
26
40
17
2
20