Ramsey Winch RPH-20000 (SPEC. FOR CHEVRON) User Manual
Page 12
10 OM-914032-0503-D
11.Place (2) gear carrier assemblies into ring gear meshing carrier gears with ring gear. Make sure
that ring gear and carrier assemblies are securely against end bearing (item #9). Inspect cover o-
ring for damage and replace if necessary. Attach cover to ring gear. Use (8) capscrews (item
#15) to secure gearbox cover to gear housing end bearing. Torque capscrews to 18 ft. lbs. each,
in criss-cross pattern.
12. Pull rod from air cylinder as far as possible. Slide washer (item #33) over setscrew (item #22)
and against nut attached to air cylinder rod. Place setscrew into hole of shifter shaft (item #12).
Attach new air cylinder (item #30) and gasket (item #33) with sealer, to adapter using (4)
capscrews (item #23). Apply Loc-tite PST thread sealer to threads of capscrews. Torque
capscrews to 5 ft. lbs. each, in criss-cross pattern.