Rapid-Air RAPID TOUCH WITH BASE: RTB - Manual (Page 5)

ADJUSTMENTS
PAYOUT/REWIND SWITCH:
In the payout mode, the device that is receiving the signal from the RTB will increase in speed
as the depth of the loop becomes smaller.
In rewind mode, the device that is receiving the signal from the RTB will increase in speed as
the depth of the loop becomes larger.
NO STOCK
This relay has a contact controlled by an external switch. The switch should be mounted near
the RTB and wired to the unit. If the external switch is used as a no-stock switch, then the con-
tact should be closed when material is present. If not using this accessory then a jumper must
be in place for the unit to work.
MECHANICAL
The mechanical assembly of the RTB was designed to be very versatile. It has 3 main mechani-
cal adjustments, which are as follows:
The height of the can assembly can be adjusted upward by a maximum of 24 inches in incre-
ments of 1 inch.
The arm holding the touch probe cans can be adjusted a maximum of 4 inches in increments of
2 inches.
The touch probe cans can be adjusted to a maximum opening of 24 inches in infinite incre-
ments.
Caution: Always tighten every bolt securely as the unit depends on a proper and com-
plete path from the probe cans to the electrical control panel in order for the control to
work properly.
The feet of the RTB has 4 holes drilled through for mounting the unit to the floor. The hole is a
clearance for a 1/2 inch bolt.
14 5