Reelcraft Series LG Cord Reels Light Cord Reels - Manual (Page 2)

Spring Driven Light Cord Reel
Page 2 www.reelcraft.com
OPERATION AND MAINTENANCE INSTRUCTIONS
1. Plug the unit into a 120V AC outlet. The Lite® power supply cord is UL listed and meets OSHA standards.
2. To start, depress and release switch in handle of worklight. The lamp will flicker as the automatic starter
lights the lamp. To turn off depress, and release again.
3. Disconnect the power supply before servicing.
4. Keep the unit free from grease and dirt by using a damp cloth with mild detergent, or waterless hand
cleaner. This removes dirt from scratches in the outer tube and will provide the best light output at all
times. If the tube is damaged or badly scratched, it is easily replaced and is available as a replacement
part (see opposite page for contact information).
5. Do not use solvents such as gasoline to clean unit or cord as it makes the parts brittle. Do not allow brake
fluid to contact the outer tube as it will cause permanent damage.
6. Regular cleaning of cord will prolong cord life.
RELAMPING
UNPLUG LIGHT BEFORE RELAMPING! Unscrew outer tube from handle of light and remove. Pull lamp from
socket and replace. Before screwing outer tube back into handle, make sure lamp fits securely inside the outer
tube lamp indentations. NOTE: Continue to screw the outer tube into the handle until it “clicks” into place.
The Lite with tool tap
Optional Wall or
Ceiling Mount
180° Rotation
Installation
Ceiling Mount
360° Rotation
Optional Wall or Ceiling Mount
1. Select location within 2 feet of an electrical outlet.
2. Attach U shaped bracket “A” to solid part of the wall or ceiling using screws (provided).
3. Place hanger bracket “B” inside U shaped bracket “A” lining up small holes in bracket.
4. Insert locking pin “C” through lined-up holes. Be sure to bend the end of locking pin as shown.
Optional Ceiling Mount
1. Select location within 2 feet of an electrical outlet.
2. Screw the hanger hook securely into the ceiling. Hook must screw into wood frame behind drywall.
3. Hang reel on hook.
4. Close hook with pliers to prevent reel from coming off. Refer to point “A”.
5. Adjust cord stop so light or outlet hangs at desired length when cord is retracted.
A - Close
Hook
◄
A
C
Cord
Stop
◄
B