Reelcraft Series LH Hand Crank Cord Reels (LH3100) - Manual (Page 2)

Hand Crank Power Cord Reel
Page 2 www.reelcraft.com
1. DO NOT handle this fixture or try to plug it in when your
hands are wet or damp or when you are standing on a wet or
damp surface.
2. This fixture MUST ALWAYS BE USED in accordance with
all electrical and safety codes and ordinances, including
the most recent National Electric Code (NEC) and with the
Occupational Safety and Health Act (OSHA) Volume 1 on
General Industry Standards and Interpretations.
3. ALWAYS make certain that the power source conforms to the
rating on the fixture.
4. ALWAYS disconnect the power before servicing or inspecting
the fixture for any reason.
5. This fixture is ONLY FOR USE ON 110-125V, 3 wire, grounded
circuits and it’s cord equipped with a 3-pronged grounding
plugs. TO REDUCE THE RISK OF ELECTRICAL SHOCK con-
nect only to listed 3 conductor extension cord (see chart) and
plugged into a properly grounded outlet.
6. IMPORTANT SAFETY INSTRUCTIONS: This product comes
equipped with a 3-pronged grounding plug, DO NOT
ATTEMPT TO DEFEAT THIS FEATURE. Removal of the
grounding pin can result in a risk of electric shock.
7. CAUTION: This fixture is not rainproof and should not be used
outdoors or potentially wet locations to prevent risk of elec-
tric shock.
8. This fixture is not explosive-proof, DO NOT use in potentially
dangerous locations, such as in flammable or explosive
atmospheres.
ASSEMBLY / OPERATION
1. Connect recommeded extension cord to short cord in the
center of the reel hub. The connection of the short cord (A)
and extension cord (B) should be positioned inside the 4 sil-
ver steel slats (C) as shown in figure 1.
2. To operate, plug extension cord into 110-125V grounded
outlet. LED power indicator (D) figure 2 will confirm power to
the 4 outlets (E). A maximum of 1875 watts, 20 Amps can be
powered through the 4 NEMA 5-20R outlets.
3. Exceeding the maximum rating will trip circuit protector (F)
and is indicated when the reset button pops out. Remove
overload, wait two minutes, and press reset button to restore
power.
4. Cord is easily wound on the cord tender with use of the large
knob on the front face of the unit. Cord can be threaded under
guide bar (G) to aid in winding.
5. To adjust drag on the spool, tighten the center jam nut (H) to
increase tension and loosen to decrease.
MAINTENANCE
Remove dirt and grime as soon as it accumulates. Use a soft,
damp cloth and a mild soap, if needed. Be sure not to get the
electrical plug wet. NEVER submerge any part of the cord tender
in any solution to clean it. DO NOT USE solvents such as gasoline,
turpentine, etc. to clean unit.
Owner’s Instructions
Heavy Duty Portable
Power Cord Reel
CAUTION: Read all instructions and warnings before operating!
SAVE THESE INSTRUCTIONS! READ ALL INSTRUCTIONS!
WARNING: To avoid serious injury or death from
electrical shock or fire.