Reelcraft Safe-T-Reel Welding Cable Reels (T-14xx-x) - Manual

Operating Instructions
Reelcraft Industries, Inc. • 2842 E Business Hwy 30, Columbia City, IN 46725
Ph: 800-444-3134 / 260-248-8188 • Fax: 800-444-4587 / 260-248-2605
Customer Service: 855-634-9109 • [email protected] • www.reelcraft.com
Safe-T-Reel Welding Cable Reels
Model Numbers:
T-1460-0 T-1460-2 T-1460-4
T-1460-7 T-2462-0 T-2464-0
Read this manual carefully
before installing, operating
or servicing this
equipment.
IMPORTANT
Four 1/2” diameter mounting holes
Dimensions
T-1460-X
A 19”
B 18”
C 6”
D 6”
E 6 1/2”
F 16 1/4”
A
B E
C
D
• Ensure that only a qualified electrician installs/services this
equipment.
• Ensure that power supply voltage does not exceed maximum
voltage rating of reel.
• Ensure that reel is properly installed before connecting to power
supply.
• Ensure that all electrical power is removed from reel before ser-
vicing.
• Check for frayed/broken wires before each use.
• Pull electrical cord from reel by grasping the electrical cord
itself, not the work device.
• If an electrical malfunction should occur, remove power from reel
immediately.
• Ensure that reel, electrical cable, and equipment being serviced
are properly grounded. Use an ohmmeter to check ground
continuity.
• If reel ceases to unwind or rewind, remove power immediately.
Do not pull or jerk on electrical cable!
• Treat and respect the cable reel as any other piece of machinery,
observing all common safety practices.
WARNING: Even low voltage can cause irreparable damage or
death! Exercise extreme caution while operating or servicing this
equipment.
SAFETY
Injury and/or equipment damage may result if proper safety precau-
tions are not observed.
Form# 1105-801 Rev: 3/2014
T-2464-0
A 38”
B 18”
C 6”
D 6 1/2”
E 16 1/4”
T-2462-0
A 19”
B 18”
C 6”
D 6 1/2”
E 29”
Four 1/2” diameter mounting holes Four 1/2” diameter mounting holes