SaltDogg SHPE Controller (3014199) - SHPE0750, SHPE1500, SHPE2000, SHPE4000 - Manual

1
TM
RED WIRE-
BATTERY POSITIVE
BLACK WIRE-
BATTERY NEGATIVE
1
2
3
4
5
6 7 8
GEAR MOTOR MAY
HAVE INTEGRATED
HARNESS
INPUT WIRES
RED WIRE (10AWG) - BATTERY “+”
BLACK WIRE (10AWG) - BATTERY “-”
RED WIRE (16 AWG) IGNITION “+”
OUTPUT TERMINALS/WIRES:
A - BROWN (20 AMP FUSE) - LIGHT
B - RED - AUGER POSITIVE
C - GREEN - AUGER NEGATIVE
D - BLACK - VIBRATOR NEGATIVE
E - GRAY (30 AMP FUSE) - VIBRATOR POSITIVE
F - YELLOW - SPINNER POSITIVE
G - BLUE - SPINNER NEGATIVE
9049 Tyler Blvd. • Mentor, Ohio 44060
Phone (440) 974-8888 • Fax (440) 974-0165
Toll-Free Fax 800-841-8003 • saltdogg.com
Installation Instructions
3014199 SHPE Spreader Controller
Serial Number 15000 and higher.
Buyers Products Company assumes no responsibility for installations not made in accordance with these instructions.
NOTE: Always disconnect battery before attempting to install
electrical components on your vehicle.
1. Mount the controller in a convenient location in the truck
cab. It is not recommended to mount the controller directly in
front of heat vents. Allow ample air space around controller.
2. Route both wire harnesses into truck cab through firewall
(it maybe necessary to drill holes). Insulate hole to avoid
water leaks. Insure no wires are nicked or damaged during
installation.
IMPORTANT!
Before installation, check your truck's battery and alternator
using load tester. Do not proceed to installation if truck elec-
trical system does not function properly.
3. Connect the round connecter on the wire harness to the
control box.
4. Connect the 2-pin rectangular connector on the power
cable to the control box.
5. Lay out a path for the power cable to the battery, use
quick ties to secure power cable.
DO NOT CONNECT TO BATTERY AT THIS TIME!
6. Lay out path for wire harness to the rear of the vehicle.
Stay clear of the exhaust system. Excess heat can damage
the wire harnesses. Use quick ties to secure harness to
underbody.
7. Connect the wire harness to the motors and vibrator.
8. Connect red wire to battery positive terminal. Connect
black wire to battery negative terminal.
THIS IS A WIRE GROUND ELECTRICAL SYSTEM! NO
CONNECTIONS TO TRUCK’S FRAME OR BODY ALLOWED!
In trucks with dual battery systems always connect power
cable to primary battery (larger capacity/ truck starting
battery).
Controller Operation
CAUTION!
Do not mount controller in the way of air bag deployment!
Parts List
1 3014199 1 CONTROLLER, SHPE, SALTDOGG
2 3006842 1 POWER CABLE, CONTROL BOX
3 3006724 1 WIRE HARNESS, MAIN
4 3006753 1 WIRE HARNESS, CHUTE
ITEM PART NO. QTY DESCRIPTION
5 3006833 1 GEAR MOTOR 12 VDC. SPINNER
6 3006844 1 WIRE HARNESS
7 3009995 1 GEAR MOTOR, AUGER SHPE
8 3007416 1 VIBRATOR 200 LBS 12 VDC
ITEM PART NO. QTY DESCRIPTION