SaltDogg LS5 Liquid Spray System - Manual

1
TM
9049 Tyler Blvd. • Mentor, Ohio 44060
Phone (440) 974-8888 • Fax (440) 974-0165
Toll-Free Fax 800-841-8003 • saltdogg.com
Installation & Operator’s Manual
LS5 Liquid Spray System 2 x 105 Gallon Tanks
Installation Instructions
1. Position pump enclosure bracket
(#3028485) 4” from rear gusset on driver side
of hopper spreader, (see fig. 1). Make sure
bracket is rested on hopper’s sill.
2. Weld pump enclosure bracket (#3014084)
in place as shown in fig.1.
3. Position reservoir brackets (#3010977),
gussets (#3011128) and bracket tie downs
(#3011124) as shown in fig.2. Weld all parts in
place as shown in fig.2 and fig.1 on both sides
of spreader.
4. Place reservoirs (#3010816) on brackets
and secure them using retainers (#3010979) as
shown in fig.3.
5. Use three (#1496505) (see fig. 3) 1-3/4”
x 5” ratchet tie downs to secure each
reservoir.
6. Plumb: Reservoir, ball valve, filter, pump
enclosure, and spray nozzles according to
plumbing schematic using supplied fittings,
hose, and hose clamps. Do not use Teflon
tape on threads. Use liquid thread sealant.
(see fig. 5, 6, & 7).
7. Two 11/16” diameter holes are predrilled in
the chute guide (#3010180) for installation of
two liquid spray nozzles, see fig.3. Installation
on different brands of spreaders may require
different nozzle locations.
—continued inside